house alarm, wireless home alarms,wireless burglar alarms,wireless gsm alarms
wireless home alarms,wireless burglar alarms,wireless gsm alarms
personal alarms for the elderly, devices for elderly, elderly personal alarm, personal alarms,personal medical alarms, elderly alarm, emergency button, pendant panic button
personal alarms for the elderly,elderly personal alarms,personal alarms, alarms for elderly, devices for elderly, personal medical alarms, medical alert, emergency button, pendant panic button

Wireless sensors will not register

Print
Written by You Protect   

If when trying to register a wireless sensor to the Premier Wireless Burglar Alarm it does not reply with "Coding completed" this is usually caused by the following:

1. Check that the wireless sensors have had their wireless code set. This is carried out by changing the position of the small clips located on the 12 or 13 rows of 3 pins. By placing these clips across two pins on each row a code is created that is sent to the alarm if the sensor is triggered. If all the clips are in the default position of just being on one pin then no code will be sent.

2. If the sensor is already registered to a zone on the Premier Wireless Burglar Alarm it cannot be registered to another zone. If you know which zone it was previously registered to you can delete this one from the zone. Otherwise, if you cannot remember which zone it was previously registered to then enter the factory reset code listed in the manual.

Resetting the Premier Wireless Burglar Alarm will mean any sensors that have already been coded will be de-registered and will have to be registered again.