Can We Help?
Store
- Elderly Personal Alarms
- House Alarms
- GSM Alarms
- Shed Alarms
- Camera Alarms
- Child Alarms
- Door & Window Sensors
- Vibration Sensors
- PIR Sensors
- Pet-Friendly PIR Sensors
- Panic Buttons
- GSM Antennas
- Sirens
- Gas Detectors
- Smoke Detectors
- Smoke & Heat Detectors
- Water Sensors
- Keypads
- Batteries
- Remote Control Keyfobs
- SIM Cards
- Set-up & install services
Polls
Login
Wireless Garage Door Roller Shutter Door Sensor (100m)
£19.99
(inc VAT)
[tab=Description]
This sensors are designed to be used on roller shutter doors where one part of the sensor is secured to the floor and the other part to the steel door. They can also be used on garage doors where the principle is exactly the same. Because the contact is made of metal then walking or driving over them does not present a problem.
The wireless trasmitter is housed inside the sensor which can be attached to a wall.
Features
- Wireless - will transmit up to 100m max. Typical range is 30 - 50m depending on conditions.
- On activation upper LED will illuminate
- On low battery lower LED will illuminate
- Indoor use only
Spec
- Frequency: 433 Mhz
- Width x Depth x Height approx. (cm):
- Sensor = 3.5 x 1.6 x 7
- Floorplate = 3.8 x 1 x 10.5
- Contact = 1.5 x 1.5 x 10.5
Compatibility
- Alert Pal
- Premier House Alarm
- Elite House Alarm
- Medilarm Classic
- Medilarm Pro Personal Alarm for the Elderly
Contents
- 1 x Metal floor plate
- 1 x Metal contact
- 1 x Wireless Sensor (100m)
- 1 x 12V A23 Battery (MN21/L1028/8LR23)
- 4 x Fixing screws
- 1 x Self Adhesive pad
Setup
- Either use the supplied sticky pads to attach the sensor to an appropriate structure or remove the back cover and screw this to the wall and then clip the sensor back on.
- The wireless code that the vibration sensor uses to uniquely identify itself to the alarm, can be set or altered by carrying out the following steps:
- Remove the back cover
- Locate the rows of 3 small pins that point upwards
- Remove the series of small clips (jumpers) that are attached to one of the pins in each row.
- Reposition each clip in any order across two pins on the same row (a clip is not required on every row). If you require two sensors to be on the same alarm zone then just make sure they both have the same pattern of clips so they generate the same wireless code.
Customer Reviews:
There are yet no reviews for this product.
Please log in to write a review.
